Flip-Pod® 400 Vacuum Clamp

SKU
FPKIT400SEAL

Carter Flip-Pod® Vacuum Clamp System with 400 pods plus assorted accessory placement pods.

California Residents

Warning: Cancer and Reproductive Harm *

www.p65warnings.ca.gov

The Carter Flip-Pod® Vacuum Clamp System for CNC routers enhances the utility and flexibility of your router. This innovative vacuum workholding system was the winner of the 1994 Challenger Award for Technical Merit at the International Woodworking and Supply Fair in Atlanta, GA.

Adaptable to almost any CNC router equipped with a vacuum pump and table, the Flip-Pod™ system replaces the more traditional spoil-board with a Flip-Pod™ panel made of tough 2" UHMW material. Into this panel are routed a pattern of circular cavities, each of which can hold a single Flip-Pod™. Each Pod can be placed in either the down position (flush with the top of the panel) or the up position (raised approximately 1 1/8 inch above the panel). In the down position, each pod acts as a vacuum switch, preventing airflow through the cavity. In the up position, the pods allow vacuum to act through the cavity and pod to hold the underside of the material being processed. Thus the material is firmly held in a raised position above the router table surface making it easy to perform edge boring or edge shaping.

The Flip-Pod™ 400 Vacuum Clamp kit includes:

•400 Flip-Pod™ Vacuum Clamp assemblies

•400 Large gaskets for the panel

•6 Retractable locator pins

To find a UHMW supplier in your area, click here to connect with the IAPD site.

Flip-Pod Vacuum Clamp commonly asked questions.